Hi,Thanks for your instructions, I have been working with it for a few days now. I have been following the Arduino site, and I have made a few modifications, I will post the code on the site in a few days.Since I posted my previous comments, I have been testing my tinkers, and I can confirm that the Arduino is in fact transmitting data. I can see it on the virtual organ software as a Device. My tinkers are of course much more sensitive than yours, but mine is the same. I know the code works, because I can upload it to the Arduino and have it working. The problem is my tinkers cannot see it.I have tried using a different USB to serial converter (USB-RS232) and the same thing happens, it is not showing up. I think it has something to do with the fact that I am using MidiOx, and not Oni. I will try to change the code to use the MIDI_CREATE_DEFAULT_INSTANCE() in oni, and see what happens. It might be a difference between the two programs. (I do have the Arduino and seperately the virtual organ software)I will also try to make it so that when I call the code the Arduino calls out to the tinkers as well. I will also look into the MidiOx and Oni USB-RS232 specific code if I can find it. I will post the code as soon as I find it and try it out. I can only assume it is a problem with the MidiOx. I will post the code once I find it.
Hi,I have followed your instructions, but I have just been at a loss as to where I am supposed to send the data, I have tried using the MidiOx, and the Oni software, I can upload the code fine, with out any errors, but I cannot get the data to my tinkers. I have tried using a different USB to serial converter, and the same thing happens, it is not showing up. I will try to change the code to use the Midi_CREATE_DEFAULT_INSTANCE() in oni, and see what happens. It might be a difference between the two programs. (I do have the Arduino and seperately the virtual organ software) 827ec27edc